Residential Wind Turbines & Wind Power for Marine, RV’s and more

The future of affordable, renewable residential energy is wind. You’ll be amazed by the wind power you can harness for your home or boat with the following wind generators and turbines. Wind is the future of tomorrow! Depending on the model, a small residential wind turbine with a rated capacity of 1.8 KW and a rotor of 12 feet has the ability to produce an estimated 400 KWh when the wind is breezing at a mere 12 mph. Wind generators and turbines are also designed to last, e.g. Southwest Wind provides estimates of 20 years on some of their products. Think of the favor you’ll be doing Mother Nature when you buy into wind!

Click on This

WIND POWER LINK:

The Air-X Marine Wind Turbine is by far the world’s number one selling small wind turbine for Sailboats and other boats. Wind is the future of tomorrow!

This Marine grade Wind Turbine for boats has marine powder coating and stainless steel fittings for corrosion protection in a marine environment.

With 400 Watts of power at 28 mph winds, the powering possibilities are endless. In just a few years, the AIR X marine has become the standard wind turbine among blue water cruisers selling over 70,000 turbines worldwide.

The new microprocessor-based speed control results in increased performance, improved battery charging capability and the reduction of “flutter” noise. The controller allows for peak-power tracking of the wind by optimizing the alternator’s output on all points of the cubic curve and then efficiently delivers the energy to the battery. The turbine’s smart controller allows it to actually control blade rotation speed thus eliminating the buzzing noise commonly found with most small wind turbines. Furthermore, a new series of carbon-reinforced blades with a modified pitch angle further increases power production. The new electronics are a considerable improvement over the AIR 403 controller that consists of diode-rectification and a simple on/off voltage switch.

Much Lower Noise:
Previous AIR wind modules relied on their aero-elastic blade design for protection in high winds, causing loud flutter noise in winds above 35 mph (16 m/s). AIR-X’s circuit monitors the wind speed and electronically slows the blades as it reaches its rated output preventing it from going into flutter. This results in a much quieter wind turbine. In high winds, the AIR-X will continue to produce power at a reduced level until the wind decreases, at which point maximum output will resume.

Improved battery charging:
Previous AIR designs required 300-400 amp-hour battery banks so the trickle charge of the wind turbine could be adequately absorbed. The AIR-X’s charge controller periodically stops charging, reads the battery voltage, compares it to the voltage setting and if the battery is charged, it completely shuts off all current going to the battery. This function is performed within a few milliseconds. The closer the battery is to reaching its full state of charge, the more often the AIR-X’s circuit repeats this action. This means any size battery bank from 25 to 25,000 amp-hours or higher can be charged safely. When the battery has reached its charged state, the AIR-X will slow to an almost complete stop. Only when the battery has dropped below its voltage set point will it startup and resume charging. The Benefit: Extended battery life, no overcharging.

Lower stress design:
AIR-X limits power on the input side of the electronics by controlling the torque from the blades. The power no longer has to be dissipated by the electronics resulting in lower stress on the circuit, bearings and other materials. Furthermore, stress on wind turbines occurs primarily in high winds. Under these conditions, the electronic stall design reduces the blade speed to 600 rpm, thereby significantly reducing turbine and tower loading while still producing power. The Benefit: Greater confidence in turbine operation in high wind conditions without manually operating the stop switch. Improved resistance to the effects of the sun, wind and water: AIR-X marine has vastly improved body preparation and applications of the marine paint during manufacture, ensuring durable powdercoat protection of the body and internal components, even when subjected to the most extreme sun, wind and water conditions.